The longstanding expert knowledge of TSUBAKI KABELSCHLEPP in the field of cable carriers for cranes is currently paying off in France. In several project steps, the existing cable carriers on the overhead cranes are being replaced with hybrid cable carriers of type MC0650 from the M series. These are perfectly up to the task of the tough ambient conditions in the metalworking industry, due to their quick and easy installation and the low maintenance requirements, among other things.
Customized hybrid carrier solutions
Hybrid cable carriers of type MC0650 RS with aluminum stays from the M series by TSUBAKI KABELSCHLEPP are used for this project. Since the start of the project, removal of the existing systems and installation of the new technology have been the responsibility of ACTEMIUM Levage, a specialist firm for maintenance and refurbishment of crane systems with headquarters in Héricourt, France.
The RS aluminum stays are suitable for light to medium loads and are customizable in 1-mm increments up to an inner width of 800 mm. They can be installed with a simple wrench and allow for extremely fast opening and closing of the cable carriers because they can be easily released on the outside and inside with a 90° twist. The robust link plate design not only makes the sidebands particularly sturdy, but also enables very easy assembly with the easy-to-install locking bolts. Other benefits are offered by the encapsulated, dirt-resistant stroke system and the 2-disc principle of the cable carriers that minimizes link wear to extend the service life.
