Until now, the M8 front fastened panel mount connectors have only been available with dip-solder contacts. With single wires in the device, Franz Binder offers the option of positioning the connector through the housing from the inside and fastening it from the front. This is required if, for example, the PCB is pre-mounted with the connector and then assembled in the housing. The 3, 4 and 6 pole panel mount connectors in nickel-plated brass housings are fitted with key surfaces that form anti-torsion safety devices. The O-ring is installed as a seal for the customer housing. For easier assembly the hexagonal nut is not installed. The single wire length is 200 mm, while longer versions are available on request. Mating halves and female cable connectors in M8 and snap-in designs can be connected to the 3 and 4 pole male panel mount connector.
Edited by: Teoman Tugsuz
