ENEMAC proposes a torque limiter type ECI, with wide bearing position, used especially on packaging machine and conveying system. The mounting for adapting of pinion-end elements was designed particularly wide, which relieves the addition of crown gears, chain wheels or gears.
Torque limiter equipped with a synchronous hurtling
Precise limitation of torque is guaranteed through the specially developed disc springs, which also allow a very wide torque range, without the need of replacement of springs. The fully developed ball-hurtling-principal interjects within a few angular degrees the drive chain between motor and machine, the separation occurs compulsory and purely mechanical. These torque limiters are generally equipped with a synchronous hurtling, which means drive part and pinion-end element have only a tab location within 360 degrees.
Torque limiter with fourteen different sized with a torque range from 2 to 900 Nm
Torque transmission from engine shaft occurs through a keyway on the hub of the coupling. The particular drive part (crown gear, chain wheel, gear, bead or the like) is added with a floating bearing and mounted on the bearing surface of the coupling. For transmission of torque it suffices a bolted flange connection. Eminently for short journal extensions the user gets a good possibility with this type of coupling for connecting as well wide output-elements. The coupling then occurs as an extension of axle. On request the type ECI can also be delivered in stainless steel. Torque range from 2 Nm up to 900 Nm are possible in 14 different sizes.
